IL Remnants of my Maxima
Remnants of my Maxima (springs, sway, MAF, etc...)
Since my Maxima is gone, I have a few random parts for sale. This is a collection of item I either used, intended to use or kept as spares. Pictures follow the descriptions.
The next customer which spends greater than $40 will receive an IAT thermistor.
Prices do not include shipping, which may be unavailable for the larger items, and preference is given to locals that can pick-up the parts.
3) Stillen rear sway bar, purchased from a 4th gen owner, never personally used; hardware is in rough shape and there is some material missing from the bar due to rubbing ($125)
5) New Nissan fuel filter and pump assembly O-ring ($10)
6) Stillen muffler section, used on two vehicles with unknwon total mileage, scraps on the tip's bottom and some rust on mating flange (should seal without a problem) ($75)
7) Used (105k mile) MAF with a new MAF tube, was replaced trying to remedy a driveability issue but the new unit made no improvement ($45)
8) Purolator PureOne air filter ($5)
9) Ignition coils (3), purchased from another .orger, but never personally used ($17/coil)
10) Random Technologies high flow catalytic convertor, again purchesed used, but never personally installed ($80)
12) Floor mats in good condition and in charcoal, all but drivers side ($20)
13) Brake and clutch master cylinder rebuild kits; I got lazy and bought new masters rather than use these ($7.50)
14) MOOG 23mm SE sway bar bushings ($5)
15) POS engine cover ($7.50)
Worn out OEM parts removed from my vehicle which may benefit others. These are free for pick-up (beer donations accepted), or shipping (you pay).
-LCAs with bad ball joints, good for those looking to swap in ES bushings and MOOG ball joints
-Struts (fronts) to cut-up for use Koni inserts
-Motor/transmission mounts for ES bushings or polyurethane filling; the lower mounts were actually in good condition and could be reused (I'll try to get pictures later)
-5.5 gen OE front brake calipers
-5.5 6MT 114k mile axles; removed to troubleshoot a noise and never reinstalled; passenger side carrier bearing has some play
3)
5)
6)
7)
8)
The next customer which spends greater than $40 will receive an IAT thermistor.
Prices do not include shipping, which may be unavailable for the larger items, and preference is given to locals that can pick-up the parts.
3) Stillen rear sway bar, purchased from a 4th gen owner, never personally used; hardware is in rough shape and there is some material missing from the bar due to rubbing ($125)
5) New Nissan fuel filter and pump assembly O-ring ($10)
6) Stillen muffler section, used on two vehicles with unknwon total mileage, scraps on the tip's bottom and some rust on mating flange (should seal without a problem) ($75)
7) Used (105k mile) MAF with a new MAF tube, was replaced trying to remedy a driveability issue but the new unit made no improvement ($45)
8) Purolator PureOne air filter ($5)
9) Ignition coils (3), purchased from another .orger, but never personally used ($17/coil)
10) Random Technologies high flow catalytic convertor, again purchesed used, but never personally installed ($80)
12) Floor mats in good condition and in charcoal, all but drivers side ($20)
13) Brake and clutch master cylinder rebuild kits; I got lazy and bought new masters rather than use these ($7.50)
14) MOOG 23mm SE sway bar bushings ($5)
15) POS engine cover ($7.50)
Worn out OEM parts removed from my vehicle which may benefit others. These are free for pick-up (beer donations accepted), or shipping (you pay).
-LCAs with bad ball joints, good for those looking to swap in ES bushings and MOOG ball joints
-Struts (fronts) to cut-up for use Koni inserts
-Motor/transmission mounts for ES bushings or polyurethane filling; the lower mounts were actually in good condition and could be reused (I'll try to get pictures later)
-5.5 gen OE front brake calipers
-5.5 6MT 114k mile axles; removed to troubleshoot a noise and never reinstalled; passenger side carrier bearing has some play
3)
5)
6)
7)
8)
9)
10)
10)
Last edited by 2slow; May 5, 2011 at 03:54 PM.
I didn't record the build date, but I'm fairly certain it was built in late '01.
PM'd.
I haven't, but there purchased from a respected orger so I assumed they were kosher. As tested per this thread, I have the following which seemingly indicates they are all good.
$15 for the pair.
PM'd.
I apologize to those who replied/PM'd without response; I stopped coming here since there wasn't much interest and I no longer have a Maxima.
So, I'm back to finally sell this stuff and free up some space in my basement. The first post has been updated.
So, I'm back to finally sell this stuff and free up some space in my basement. The first post has been updated.
