Anyone have their powerslot rotors turned down?
#1
Anyone have their powerslot rotors turned down?
Anyone with powerslot rotors, have you ever had them turned down/resurfaced?
If so, did you take them to any old machine shop? Or do the slots require specialized turning process?
Thanks in advance for any info
If so, did you take them to any old machine shop? Or do the slots require specialized turning process?
Thanks in advance for any info
#2
Have you tried emailing Powerslot and asking them? www.powerslot.com seems to be their website.
#3
Originally Posted by ajahearn
Have you tried emailing Powerslot and asking them? www.powerslot.com seems to be their website.
Their site is nothing more than "look how wonderful our product is", nothing in the way of technical support or even simple FAQ's.
Also emailed them, but no response.
Hoping this board will be a tad more helpful/responsive
#4
Any good shop can turn the rotors. Have the shop set the dial to .1 for 2 passes and then .5 for the last pass.
Originally Posted by Maximus03SE
Uhmm, yeah I did that.
Their site is nothing more than "look how wonderful our product is", nothing in the way of technical support or even simple FAQ's.
Also emailed them, but no response.
Hoping this board will be a tad more helpful/responsive
Their site is nothing more than "look how wonderful our product is", nothing in the way of technical support or even simple FAQ's.
Also emailed them, but no response.
Hoping this board will be a tad more helpful/responsive
#5
Originally Posted by tkarrh
Any good shop can turn the rotors. Have the shop set the dial to .1 for 2 passes and then .5 for the last pass.
Thread
Thread Starter
Forum
Replies
Last Post
tarun900
4th Generation Maxima (1995-1999)
19
12-20-2021 06:57 PM
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM