Because i am an idiot i bought one of those projector headlight housing for my 2000 maxima. Now i have a H3 hella system sitting infront of me and i cannot figure out a way to hook it up. anyone else do this

 

before u cut and rewire everything, those projectors dont have a good beam pattern and aren't designed for HIDs

 

I would say give it a try, but rather than just cutting the wires use male and female connectors so that if you don't like the way they look you can put them in your foglights. I'm very interested in how this comes out as I too have the projectors and have been thinking about geting a pair of h3 hids.

As far as how to wire them up? I don't really know but I would try to follow the wires up starting with the socket and figure out which is + and -. Did the hids come with instructions? How much were they and where did you get them?

 

well, if worse comes to worse, you can put them in your fogs if you want...those allow h3's...

 

i was doing fine but the only problem i have is the two negatives that come off the bulb... there is a place to put one of them... but i cant figure out the other one

 

I made the same mistake of purchasing the Halo's, i must agree that the beam pattern is prerry ****y. Thje only things thats holding me back from pulling them is that they look awsome......
I just purchased a HID kit (H3) and still haven't got it, i was wondering if you were sucesful in installing it and if you could give me up heads up about installing them !!!
your help is greatly appreciated.

 

Thats not negative, thats for your high beams