RP300zx

Alright so I know this has already been talked about before but i can't find the thread ANYWHERE and i looked for 2 hours. 2002 Maxima SE manual climate control. I turn the switch to level one nothing happens, level two full blast, level three does nothing, and level four full blast again. I took the assembly apart and I see that the switch looks like it has a tiny melted part next to one of the wire contacts in the harness connection. I am trying to figure out if its the switch, or the resistor pack on the blower, any ideas???? Also, where can i get just the switch assembly itself or resistor pack? I know everyone hates re posts but this is my last resort!!

jasonmax

iTrader: (2)

replace the switch
if it still doesn't work, check the resistor

djfrestyl

iTrader: (89)

Although the issue is commonly fixed with the resistor pack on the motor, if you found a melted part on your switch that could just as likely be the culprit. I'd change the switch first, then go for the resistor pack. The switch may have to be a junkyard or part for sale here on the forum, as they will be included with a new climate control and therefore pricey. The resistor pack is a common part and Dave B can set you up with one.

Or, search for the part #'s and procedures.