Originally Posted by miksen (Post 6426521)

Thanks for the advice
.... never gave the dealer a thought cause they are soooo over priced but 85-100 is reasonable

Originally Posted by nismo_star (Post 6427661)

I'll break it down to you.

When you remove your stock carpet, have a spray can with acetone to clean your floor and you might as well clean up all the debris under the carpet from all the years of driving, and any other 'substances' dropped over time.
Clean surfaces with the acetone to get adhesive off with the remainder of the jute mat that just pulled off as you lifted your stock carpet.

You can get a non-oem supplied carpet, but be prepared to spend a day taking your interior apart including lower center console to slide carpet out, and prepare to cut to fit in your car, you must save all clips along side sills, and need to use a suitable tool to poke holes for those clips. Keep in mind you will have to make several cut outs for seatbelt locations, seat positions, and where the rear seat locks into. Use a sharp razor, and change as many as necessary. If you miss with a good razor and cut yourself that wound will heal faster than one with a bad razor :) (Personal experience)

You can go OEM from the dealership or DaveB yes it is very expensive but all the jute matting and all clips should be there, be prepared to possibly take apart your dash again and try to avoid breaking clips on your B pillar which is between your front and rear doors.

I'd advise you to go OEM, the Non OEM supplied carpets are a PITA, and they don't fit as well as OEM does.

Last thing is get a good 3M carpet adhesive in a can, and spray on the jute matting.