I'm working on the wiring diagram for my UTEC before I start installing and I'm looking to get some confirmation on the diagram. This will be done using the ECU connector from a dead ECU and hopefully a pigtail out of a junkyard car. I know its hard to see the injectors and ignition, but I'm not worried about those, I mostly just want to make sure that I have all the connections that are needed and none are missing. Any info will be appreciated. Thanks

 

all I want to know is if I have enough connections or if I am missing some in there. I have the ignition, injectors, maf, tps, ckps, ks. Any other sensors? And which power/ ground wires should go where?