Upgrading my injectors
I did a little poking around and found that some people are using 350z injectors at 330cc.
Is this the most common injector swap or are others interchangeable? |
Pointless unless you're doing 4" intake (then use 560/570s).
|
Yup, it's pointless without increasing the intake and MAF tube which will also require a tune before you run the car.
Our stock injectors are more than adequate to handle any bolt on upgrades. If you "uprgrade" the injectors you'll just end up running rich and needing a tune to lean it back out. In fact, tuning after adding bolt on upgrades like headers/intake usually involves leaning out the fuel mix. |
Originally Posted by Derrick2k2SE
(Post 9122196)
Yup, it's pointless without increasing the intake and MAF tube which will also require a tune before you run the car.
Our stock injectors are more than adequate to handle any bolt on upgrades. If you "uprgrade" the injectors you'll just end up running rich and needing a tune to lean it back out. In fact, tuning after adding bolt on upgrades like headers/intake usually involves leaning out the fuel mix. I'm gonna be doing full intake and exhaust for next spring but if it's gonna get leaned out anyways.....no point. |
Originally Posted by blowitoutyour
(Post 9122248)
Thank you sir.
I'm gonna be doing full intake and exhaust for next spring but if it's gonna get leaned out anyways.....no point. |
All times are GMT -7. The time now is 12:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands