Question on install of RSB
#1
Question on install of RSB
Hey,
Just installed an AADCO Rear Anti-Sway Bar. The car handles great and sits even, but after installing a have some free play in my parking brake. I can adjust the free play but I want to know if this is normal, or did I do something wrong to cause this (It's about an 1/2" freeplay.
Just installed an AADCO Rear Anti-Sway Bar. The car handles great and sits even, but after installing a have some free play in my parking brake. I can adjust the free play but I want to know if this is normal, or did I do something wrong to cause this (It's about an 1/2" freeplay.
#3
I checked the spring on both sides. No prob there. I'm going to loosen the whole sway bar back up and see if it makes a difference then tighten it down again.
RalphW
RalphW
Originally posted by WizzaMax
Check on the back of the caliper to make sure you did not disconnect (by mistake) the small spring for the e-brake cable right next to where it feeds into the caliper.
Check on the back of the caliper to make sure you did not disconnect (by mistake) the small spring for the e-brake cable right next to where it feeds into the caliper.
Thread
Thread Starter
Forum
Replies
Last Post
dutch078
Wheels/Tires
1
08-03-2015 06:58 PM