Under my hood.
woah, when did you get that intake that has the filter on the top?
I have been working on mine on and off for the past couple of weeks and it is coming together I think. Waiting on my polished Injen CAI and I am still debating which STB to get. All of the above look really good especially yours Chern. Hope to have me a turbo in the near future.
The blue is darker than what it looks in the pictures and it is a anodized look on the finish and all silver pieces are metallic.
The blue is darker than what it looks in the pictures and it is a anodized look on the finish and all silver pieces are metallic.
Last edited by wildman04; Mar 23, 2008 at 04:19 PM.
I painted the lettering first let it dry and then taped over the lettering and trimmed tape to the edges of the letters. Logo, just tape it up and cut out the letters. Apply alot of pressure to the tape so you can see the edge where to trim and use a very sharp knife. Someone else might direct you to an easier way but this works. Good luck with your project.
i'll take some tomorrow ok taz and yes i'll make sure the tower brace is visable
Joined: May 2005
Posts: 10,197
From: Displaced New Yorker in Southern, MD
Thread Starter
Member
Joined: Aug 2006
Posts: 71
From: Dirty NJ
Wink. I'll do the rest.
Joined: Aug 2006
Posts: 860
From: Coral Springs, FL
I painted the lettering first let it dry and then taped over the lettering and trimmed tape to the edges of the letters. Logo, just tape it up and cut out the letters. Apply alot of pressure to the tape so you can see the edge where to trim and use a very sharp knife. Someone else might direct you to an easier way but this works. Good luck with your project.
Joined: May 2005
Posts: 10,197
From: Displaced New Yorker in Southern, MD
Wink. I'll do the rest.
Joined: Aug 2006
Posts: 860
From: Coral Springs, FL
I think I remember reading a post while ago that said you didn't have to sand.... I am interested in this too so I can paint mine ..... KCMaxx, Ap53?
