Where can i find the lowest price for a front bumper stillen lip, other then their website which is like $260 for a lip that is only primed??
|
Originally Posted by KillaKam
(Post 7023327)
I have removed all Stillen products from this list due to the fact that I do not recommend doing business with them. There customer service is horrible and they do nothing but lie to you about their products. The Stillen exhaust for the Maxima has been updated with the correct information on their website after I have opened a dispute with them on BBB.com (Link for your review to be posted soon). I do not recommend doing any business with you but that choice is up to you guys.
The intake sounds GREAT! |
Originally Posted by CheddarPhil
(Post 8345055)
Dude, why are you ragging on Stillen b/c you had a bad experience with them? I just bought my intake from Stillen and I had ZERO issues. My only complaint is that the installation instructions were a little "iffy," but I still managed to get the install done in a reasonable amount of time. (1.5 hours)
The intake sounds GREAT! |
PLASTDIP GRILL
Anyone have any idea where I can go here in NY (Queens preferably) to get my front grill plastidipped? I dont want to take the chance of doing it myself and f-ing it up.
|
Originally Posted by Mario66
(Post 8345404)
Anyone have any idea where I can go here in NY (Queens preferably) to get my front grill plastidipped? I dont want to take the chance of doing it myself and f-ing it up.
In short, sand chrome (optional for better adhesion), clean up grill, spray 12" away in a sweeping left to right or right to left motion accross each bar. Wait 30 min between coats. Repeat 5x. Blow dryer also helps. Since Im OCD, I removed Nissan emblem. I didnt plasti dip chrome frame and separated that from center "honeycomb" grill. |
How do I pop the grill out? Do I have to remove that plastic covering once I open the hood to access the grill? I dont want to take the chance of breaking the grill when Im removing it or it being loose when I put it back in.
|
Originally Posted by Mario66
(Post 8345618)
How do I pop the grill out? Do I have to remove that plastic covering once I open the hood to access the grill? I dont want to take the chance of breaking the grill when Im removing it or it being loose when I put it back in.
|
Originally Posted by Mario66
(Post 8345618)
How do I pop the grill out? Do I have to remove that plastic covering once I open the hood to access the grill? I dont want to take the chance of breaking the grill when Im removing it or it being loose when I put it back in.
http://forums.maxima.org/7th-generat...rille-how.html And here's the thread you'll want to follow. http://forums.maxima.org/7th-generat...p-threads.html Good luck |
Originally Posted by rcjunkie
(Post 8345799)
Most of this stuff is available with the search feature. Here's some info on removing the grill.
http://forums.maxima.org/7th-generat...rille-how.html And here's the thread you'll want to follow. http://forums.maxima.org/7th-generat...p-threads.html Good luck Thanks. Now I have a project to do next Saturday if Im not working. Sweet |
Originally Posted by Mario66
(Post 8345875)
Good looking out Junkie.
Thanks. Now I have a project to do next Saturday if Im not working. Sweet |
|
Wondering if anyone on here has gotten the Headlight covers for their Maxima from here. My question is does it just go over the low and high beam part of the headlights or does it also go over the turn signals?
http://www.headlightarmor.com/09-10-...ting-kits.aspx |
Originally Posted by PSU09MAXIMA
(Post 8347316)
Wondering if anyone on here has gotten the Headlight covers for their Maxima from here. My question is does it just go over the low and high beam part of the headlights or does it also go over the turn signals?
http://www.headlightarmor.com/09-10-...ting-kits.aspx |
I was thinking the same thing. I just put 8k top and bottom & I was going to do the smoke tint to my headlights... So I'm debating if I should tint them....
|
Carbon fiber hood. Is it listed in this thread?. Found some last night.
|
Originally Posted by Jam_Roc
(Post 8416443)
Carbon fiber hood. Is it listed in this thread?. Found some last night.
|
|
|
this hood looks stupid lol.. dont waist your money on that
|
Originally Posted by jgoon1
(Post 8417975)
this hood looks stupid lol.. dont waist your money on that
|
not for this car imo
|
Originally Posted by slava2006
(Post 8323150)
Where can i find the lowest price for a front bumper stillen lip, other then their website which is like $260 for a lip that is only primed??
|
Originally Posted by Stlbluzoo11
(Post 8441135)
$260 is a great price! I paid $250 for my lip shipped.
Are there any drawbacks to getting this lip. Looks the same to me. |
Nothing came up in searches that was posted recently on this. Are there any aftermarket adapters that allow for true iPhone integration (play music on iPhone through car stereo while controlling it from the stereo and steering wheel controls while displaying song name and artist on the head unit) with the 2012 S trim level's stereo?
|
Just an FYI:
Ordered a nose mask off ebay from a Nissan dealership but they told me that it would take about 2 hours for installation bc they have to heat the nose mask so that it would stretch out good enough to fit snugged on the car and prevent tearing (Cool, had no problem with that) but they quoted me $165 to have it put on. The nose mask itself cost me $120 (its $149 on Nissan's site). Im thinking the nose mask will help protect my hood and bumper from road rash and insect splatter. If i have time I'll try to put it on myself. The instructions are available on techinfo or i'll take it to a someone I know who is a certified Nissan mechanic. |
Its super easy to put on, just throw it in the dryer for 5 minutes before you try putting it on.
|
Originally Posted by TMattPrice
(Post 8088603)
All:
I appreciate you all taking the time to review this question below, as I am a NooB and haven't acquired enough posts to start my own thread. Further, I did search and found a few posts speaking about my question, but the final verdict was unclear to me. I recently bought a 2010 Maxima SV Loaded Premium and LOVE the car. It drives like a dream, and has all the amenities to boot. The one part of this car I want to change is performance. I typically like to start with rims (cosmetics), then change out the exhaust system, and perhaps throw on a nice CAI system. I am stuck on the exhaust now. As many have stated, the obvious, the 3.5 V6 engine is the same as the 350Z car. Now, i'm no fool, as I do realize there are tuning differences, and different parts used on the Z car engine, as it is designed to be a performance sports car, and the Maxima is more of a luxury car with a punch, etc.. The simple fact remains: The engine is the same. I have been searching high and low on a way to get my Maxima to sound like the 350Z and/or G35 cars. The tone from the factory on those cars is music to my ears!! I don't want to go with a system like Greddy or Stillen, as I know the typical sound from those systems (I had the Greddy SP2 on my previous RX8), etc.. Question* Has no one been able to duplicate the sound of the 350Z on their Maxima (with the same 3.5 engine) by some sort of exhaust swap, muffler swap/combination, resonator change/swap, chip tuning in combination with the former, etc..?? I would be hard pressed to believe that the car doesn't have the capability of sounding exactly like its little brother (350Z) since the same engine is at play. Any suggestions/advice/sound clips would be appreciated. Thanks in advance! Matt |
what performance parts are availible for the 2012? also, is it possible to put the gtr taillights on the 2012 max?
|
Anyone try the new Philips LED DayLight 8s on a 7th gen? Where did you put them?
|
http://farm9.staticflickr.com/8205/8...2cd90fa3_b.jpgJust wanted to post this pic....
|
Custom made headlights for sale. 6000k. Halo and double LED strips. Ready to go.
$800 or best offer. Check the ebay listing: http://www.ebay.com/itm/110998103686...84.m1555.l2649 http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG |
Nice!
|
Glad this was stickied, good info!
|
Thats funny... i just saw this post... right after mine.. i cant wait to post new pics in Feb.. Y pipe and CXJ spacers are on the way too... front lip will be my final big mod on my ride.. This website gave me the base for fixing up my Max....
Originally Posted by orangeskittler
(Post 8703174)
Custom made headlights for sale. 6000k. Halo and double LED strips. Ready to go.
$800 or best offer. Check the ebay listing: http://www.ebay.com/itm/110998103686...84.m1555.l2649 http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG http://i.ebayimg.com/t/Custom-Halo-H...7E%7E60_12.JPG |
I've been looking to make my 09 maxima stand out from the crowd a little bit, and I feel the lights are the first place to start....ive been looking at some led projector headlamps but wish I had the Gs to spend on some custom ones like these.....I'm new to this site and really interested in getting ideas from everyone here.
|
Originally Posted by kjunkee
(Post 8716065)
I've been looking to make my 09 maxima stand out from the crowd a little bit, and I feel the lights are the first place to start....ive been looking at some led projector headlamps but wish I had the Gs to spend on some custom ones like these.....I'm new to this site and really interested in getting ideas from everyone here.
|
Originally Posted by Kmoney
(Post 8716123)
you can hit me up if u want custom headlight work
|
Is it possible to get the maxs headlight to give off that 2013 Audi LED look without being too cheesy. Everytime I see an new A7 is like I'm a dear caught in those LEDs. Those custom headlights above looks good but not quite there. IMHO.
|
Originally Posted by aarix
(Post 7703320)
turbo! That is all i want..... Still waiting on some company to build us a kit!
|
Hid
Originally Posted by NCBuckeye
(Post 8254183)
I'm new and also looking for HID conversion for foglights. Any brand better than the other? Also what is stock bulbs as far as K so I can get them to match? Thanks.
|
All times are GMT -7. The time now is 08:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands