Brackets to Use Z32 Calipers
#1
Brackets to Use Z32 Calipers
Was just wondering if anyone could point me in the right direction. I dont even know if they are even still available. I am looking for the brackets that allow Z32 calipers to be installed on the 6th gen Maxima 3rd gen Altima. I would like to mount a set of calipers that I just finished to see how the look on my car. Or I may just sell them to another member. I dunno, but any help with the brackets would be most appreciated....
#2
You may want to check Fastbrakes.com, I don't know if they have what you are looking for as far as the Z32 to Altima etc. but they had the Z32 to 4th gen. Maxy that I was looking for...it's worth a look.
#3
90+ views and your the only one to comment. Thank you sincerely sir for your time to post a possible solution. I appreciate your help.
#6
Yes they are. i did them, however I sold them, and then the buyer wanted rears for his 240SX so.......
It is said that the devil is in the datails, and details are what sells alot of parts/services. The Z32 calipers in this thread were sold to a guy that has a 240SX and wanted to upgrade his calipers/rotors. Well AFTER buying these, he sent me a message telling me how detailed they are in person, and then asked if I could coat a rear set for him. So I sourced out a set of rears, and just finished them tonight. Just wanted to share with my family here. I think they turned out amazing! Its a good feeling when the people that buy your creation REALLY express how they like it, and how they compare to others that friends have bought elsewhere. Here are some pics of the rears. I cant even tell you how difficult it was to isolate and highlight the "Nissan" on each of the rear calipers, ONLY because the lettering is so small. Most powder coaters I have seen that sell these dont take the time to isolate each letter, but rather just tape off the rectangle block that surrounds the "Nissan".......Lmk what you think about these!
It is said that the devil is in the datails, and details are what sells alot of parts/services. The Z32 calipers in this thread were sold to a guy that has a 240SX and wanted to upgrade his calipers/rotors. Well AFTER buying these, he sent me a message telling me how detailed they are in person, and then asked if I could coat a rear set for him. So I sourced out a set of rears, and just finished them tonight. Just wanted to share with my family here. I think they turned out amazing! Its a good feeling when the people that buy your creation REALLY express how they like it, and how they compare to others that friends have bought elsewhere. Here are some pics of the rears. I cant even tell you how difficult it was to isolate and highlight the "Nissan" on each of the rear calipers, ONLY because the lettering is so small. Most powder coaters I have seen that sell these dont take the time to isolate each letter, but rather just tape off the rectangle block that surrounds the "Nissan".......Lmk what you think about these!
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
Calabar
4th Generation Classifieds (1995-1999)
3
10-05-2015 09:57 PM
imported_Nismo_max
4th Generation Maxima (1995-1999)
2
09-21-2015 07:24 PM
-ReLLiK-
4th Generation Classifieds (1995-1999)
0
09-08-2015 12:02 PM