2k2 SE 6spd here...

i tried in the 5th gen forum. maybe i'll get more results here.
so this has been bugging me... been researching initial settings for several hours, reading the safc instruction/wiring manual, searching on the forums, reading the all motor forums about the vafc settings... searching on the apexi sites... can't get a straight answer.

What do i need for initial setup for my sensor type?

in the manual the A33 lists sensor type as HW 17, but i got a SES. which makes sense, because the wiring manual also lists the A33-Cefiro/maxima as 2.0 liter engine, and a different ECU pin layout. maybe wrong car.
i've also read 1 in 1 out in steven88's forum... but then i read that that was for vafc II only and safc II users should pay no mind.
currently i'm using HW 26 because in the manual...the Skyline, with the VQ35 and the correct ECU layout lists as a HW-26. no SES here...

but then i just found a guy who's using HW 27. What's going on here? sorry if this is a newb question... but i have been researching for quite some time now. also if there's other pertinent info i'm missing here please enlighten.

thanks, fellas

 

anybody?
bump

 

http://jime.homeip.net/S-AFCII4thGen.html
shoulda searched harder

 

...

did you even read my post?

i'm looking for the Sensor Type's for my 2k2. i know the pin locations. the safc's already installed.

 

goto the APEXi website and look in the updated documentation I just found teh pinouts for my 4th gen there.

 

St Sensor Type to HW-4 (Hot Wire Type 4), and Engine (Cylinder/Throttle Sensor) Type to 6 with a up/rightward-pointing arrow.

Set the Hi/Lo Throttle Settings to 39 and 40%.

I think, try it.