Im getting ready to do the DR MOD but dont know how to wire the switch.

The switch im using is rated 5A at 125/250VAC

The wire im using is 18AWG... HEAT = 75c or 167
I have labled the picture where the NC, NO, and C prongs are...

Some help PLEASE!!!

 

splice one wire on the dropping resistor connector (i used the green/red one)
and use the normally closed connection on the micro-switch.

 

No need to post the same thread in multiple forums....

Here you go.... in the stickies in multiple places

Here’s one source

http://forums.maxima.org/showthread.php?t=285482

/thread

 

Thanks Guys ... I just posted here also because I got NO answers in the 4th gen forum ... sorry, and thanks for the info, Aaron