3.5 emissions
Thread Starter
Joined: Feb 2003
Posts: 1,816
From: Interior Alaska
3.5 emissions
Ok, I need to register my car and have it pass emissions via a OBD-II scan. I have removed the EGR, EVAP, and MAP/BARO. I bought a 95 ECU with a production date of 04/94.
I need zero cels and not more than 2 systems in not ready.
It's my understanding that all I need is a resistor in place of the EGR temp sensor and a new TPS with a single connector going to it.
After reading the FSM, it seems that a 500k ohm resistor would work. What resistor have people been using? Or should I simply remove the EGR temp sensor and hook it up to the harness
Anything else to trick the ECU?
I need zero cels and not more than 2 systems in not ready.
It's my understanding that all I need is a resistor in place of the EGR temp sensor and a new TPS with a single connector going to it.
After reading the FSM, it seems that a 500k ohm resistor would work. What resistor have people been using? Or should I simply remove the EGR temp sensor and hook it up to the harness
Anything else to trick the ECU?
Thread
Thread Starter
Forum
Replies
Last Post
MaxRPM6
New Member Introductions
0
Sep 11, 2015 06:56 PM
carid
Group Deals / Sponsors Forum
0
Sep 9, 2015 05:06 AM
