I recently picked up an Emanage Ultimate from a buddy who had an '00 5MT, and I am looking to put it in my '01 5MT.

When it was pulled out of his car, there were several connectors left. Pics are below. What my question is if I can just plug these in, and if so where do they go, or would it just save time if I cut the connectors off and wired it myself?

Thumbnails link to large pics.





Thanks Maxima.org for your help. I have DandyMax's writeup and have looked over it a few times in preparation for this install.

 

Did you ask him where the connectors went? If it was in his car, he should know.

Also, did you see where they were connected in his car?

The second and fourth pics look like the connection to the dash harness. Did you buy the whole engine harness from him or something?

The third pic looks like some of the random connectors that are hidden away in the engine harness, no idea what they're for, Every harness I've torn apart has random connectors like that just taped up in inaccessible areas.

 

Well I emailed him and sent him pics. He said that the largest connector plugged into the ECU. But he didn't say anything else in that regard, and I've been waiting on some more info from him.

I didn't see where they connected in his car because his car was totalled and out of state.

I bought the EU and asked him that instead of cutting the wires that were tapped/intercepted he could just unplug the connectors for wherever they go, in attempts to make the install easier.

 

Anyone else have any suggestions? I know there are a lot of EU guys on here.

I'd pay to have a connector remade that's guaranteed to work.

 

So basically you got the female connectors to his male connectors that he had made...
Take out your passenger seat, cut the connectors off and get to work.