question for ppl with built motors

Reply Subscribe

Thread Tools

Search this Thread

06-02-2010, 11:53 AM

KabirUTA13

IN IRAQ MAXIMA.ORG-ING :)

Thread Starter

iTrader: (11)

Join Date: Jul 2004

Location: Northern New Jersey

Posts: 1,461

question for ppl with built motors

what type of rod bearing, main bearings and thrust bearings are you guys using... and where did u go to purchase them... thanks

06-02-2010, 02:20 PM

TurboS13Hatch

Senior Member

iTrader: (5)

Join Date: Jun 2004

Location: Houston, TX

Posts: 956

For high RPM, and/or high HP, I use ACL Race Bearings..

http://cgi.ebay.com/ebaymotors/ws/eB...d=170487710706

200 bucks for mains and rods, plus thrust washers..

Travis

06-02-2010, 10:25 PM

KabirUTA13

IN IRAQ MAXIMA.ORG-ING :)

Thread Starter

iTrader: (11)

Join Date: Jul 2004

Location: Northern New Jersey

Posts: 1,461

thanks bud... most appreciated...

06-03-2010, 08:34 AM

NiZMo1o1

Senior Member

iTrader: (45)

Join Date: Nov 2002

Location: Florida /Wade County !

Posts: 4,246

ACL race bearings as mention

06-03-2010, 08:39 AM

streetzlegend

Senior Member

iTrader: (8)

Join Date: Dec 2003

Posts: 4,097

ACL bearings here, purchased from ebay for 130shipped

06-03-2010, 03:02 PM

KabirUTA13

IN IRAQ MAXIMA.ORG-ING :)

Thread Starter

iTrader: (11)

Join Date: Jul 2004

Location: Northern New Jersey

Posts: 1,461

see i went throo the acl website... and yea they have the std .25 and .50 etc.... well im using eagle rods and im going sc boost... i would figure std shood suffice... any inputs?

06-03-2010, 03:11 PM

TurboS13Hatch

Senior Member

iTrader: (5)

Join Date: Jun 2004

Location: Houston, TX

Posts: 956

Standard will suffice.. Just make sure that you mic the crank, and mic the bearing saddles/rods with the bearings installed/TQ'd down.. This will give you your clearances, and let you know if anything needs to be adjusted.