So heres the story not sure if this will work yet. Im trying to avoid custom pistons. The build is my VG33 boring to 96mm. I done quite a bit of research and can't find the info im looking for. Im using vg30dett eagle rods which will work with no modification. The pistons im looking at are .20 over for the 350z which are 96mm. That will work once get bored. The wrist pin size is .866 in" or 22mm So thats the same as vg30 rods. So far thats all I got Im looking for center of wrist pin to piston dome and center of pin to bottom of skirt. If relatively close Im going to go for it and spend $800 for the pistons. These ones Im looking at have a full round skirt. Maybe if someone has an old stock piston laying around the can get me some measurements.