Well, thought I had done enough ninja studying not to have a thread, but I guess not. However, I think what I have left is pretty simple!

Trying to hook up my EVAP, IACV and the boost sensor. I think I am good on the IACV but I had read where there were some locations better than other due to heat. I made some brackets and have it just to the right of the intake manifold. This should be ok I think?

The EVAP, I'm still trying to mount this somewhere, but my question is, where do I pull its vacuum from? I tried following it on my other 3.0 Max, but all those vacuum routings got a little confusing and then they go to some solenoids in that whole assembly as well. Do I need those solenoids?

And for the boost sensor, it's pretty much the same question as the EVAP, do I have to run it through the solenoid or could I hook its vacuum straight up to the factory intake box?

Thanks

 

Can anybody help me out here? Trying to get this thing running!

 

heres how my IACV was mounted

 

thanks. Thats essentially what I did with mine.

Anyone else on the EVAP and boost sensor vacuum question?

 

Well, started this thing today. Sounds pretty good and runs pretty good too. However I have a pretty good ticking in the bottom end. I'm fairly certain that its the con rod bolts hitting the 3.0 baffle. I've heard a spun rod bearing and this doesnt sound like that. Have a few codes I need to address, but beyond that, no huge issues.