How would you do this?
02-26-2003, 09:49 AM
#1
How would you do this?
I am ready to install the rest of my stereo and I am curious where I should dynomat and how much. I know using strips is easier and faster than using an entire piece of dynomat but do you other members have any suggestions on methods to this?! Any help is going to be appreciated! Thanks in advance!
-King Ryan-
-King Ryan-
02-26-2003, 10:04 AM
#2
Senior Member
Join Date: Jan 2001
Posts: 1,397
Audio forum may have better info....
But I only did the trunk lid, piled up pieces on the inside of it, after removing the liner. It barely stays open because of the added weight now though. Anywhere you have rattles, put a few layers. Around the rear deck and C pillars, base of the A pillars, around the speaker housings, etc.
There is no way to do it wrong. Except to waste money on name brand dynamat. Nameless brands can be had as cheap as $50 for like an entire roll, more than enough.
I think Elemental designs is the .org guy that gives us the hookup..
There is no way to do it wrong. Except to waste money on name brand dynamat. Nameless brands can be had as cheap as $50 for like an entire roll, more than enough.
I think Elemental designs is the .org guy that gives us the hookup..