I used the 2002 wiring diagram that you had on your website. I hav an old PAC SNI-35 that I was going to use. I tried to use the White + and Black + wire on the plug that goes into the sub. It is in the section . When I have the SNI-35 spliced in, my subwoofer turns off. If I disconnect the SNI-35, it comes back on. Again, this is gonna be a temporary solution. Should I just use the Rear speaker output instead.

Any ideas or opinions is greatly appreciated!

 

I ened up using the rear speaker outputs and it does give me a signal. I used my home Sony sub to test. :-) I will use that temporarily until I get the AOEM-NIS2 kit. I still wonder why the Sub output did not work.

 

I don't know why it didn't work. I don't remember the colors, but I'm pretty sure I tapped the same wires with my LOC and it wasn't a problem.

Oh well...just wait for the AOEM-NIS2 and you will be happy..hehe