i am getting a component set (cdt 2 or 3 way). i have my amp right now which is the mtx 895 5 channel.
http://www.mtx.com/caraudio/products...thunder895.cfm my problem is bridging my channels for my components. the specs are 140 watts x 2 in a 4 ohm load. is it all right to bridge channels for interior speakears, i am thinking it might be only good for subs, and if it is how would i wire it from my amp, including the rcas


btw my sub channel is pushing 320x1 in a 2 ohhm load
2 ed 10 kxs2.2 wired to 2 ohms

thanks

would i have to use the rear rca channels for the left compenet set and the front channels for the right component set?