Hi all:
I am getting my oil cooler done pretty soon...and I have a question.

this is the only way that I can route my oil pressure sender wire, it is between the two adapters on the sandwich plate adapter. I know this location sucks. but will the oil fittings burn the plastic wire cover and damage the wire in the future?







PS, I should've bought a stillen one....this is really pain in the butt for all the money I've spent and severl times of test fitting. I've spent 250 on this porject where a stillen one is 320 and it (should) fits a lot better. well, at least mine is thermo regulated....

any suggestion is welcome!
thx for your help~

 

You should be fine. The only part of the engine that gets hot enough to burn wire insulation is the exhaust.

 

thx stephen for the reply!

 

Nice Mocal

 

sharp eyes......

 

Nah... just another to be done project... but i'm not sure if i'll have room for it if I get the FMIC.

 

I thought you have an oil cooler already? anyways. the hose coming out of the hole for power steering fluid line. it is a tight fit there to with all 4 hoses. Unless you can mount your cooler on the bottom of the passenger side....where you can route your oil hose underneath the car.


I am going to do a write-up on oil cooler. just few things that I have learned about cooler/types of fittings/choosing hoses/etc. etc.

 

is that you in the second pic?

 

me? isnt the second picture supposed to be a picture of my sandwich plate adapter? I cant see it at my work b/c cardomain is blocked my by company's IT group.

 

yes it just freaked me out while looking at it I see a eyeball satring at me

 

....I am that scary looking?


I didnt notice it too until you mentioned about it.