Just installed an ebrake handle
#1
Today I finally bought a chrome/carbon fibre ebrake handle made by Ractive. Installation was a breeze. Here's what's involved:
First I placed a piece of cardboard over the dash(around the radio) and then I pulled up on the ebrake. Next I undid the stock boot and then I hammered the ugly stock plastic cover off. After that I slid the new cover on and tightened the screws. In total the install took me 3 minutes!
The link below is a picture of a similar ebrake handle on another 4th gen max:
http://forums.maxima.org/attachment....achmentid=2297
First I placed a piece of cardboard over the dash(around the radio) and then I pulled up on the ebrake. Next I undid the stock boot and then I hammered the ugly stock plastic cover off. After that I slid the new cover on and tightened the screws. In total the install took me 3 minutes!
The link below is a picture of a similar ebrake handle on another 4th gen max:
http://forums.maxima.org/attachment....achmentid=2297
#4
Thanks guys. Too bad I don't have any pics because the ebrake handle looks amazing with my brushed aluminum dash kit. I'll hopefully have pics up soon. As for the price, I paid $45 Canadian from a local shop.
Originally posted by Greg's2kGLE
Looks good man. Where did you get it from and how much did it cost?
Looks good man. Where did you get it from and how much did it cost?
#5
Yo Yo ... Nathan ... check your Email ... it regards TORMAX!
Originally posted by Nathan
Thanks guys. Too bad I don't have any pics because the ebrake handle looks amazing with my brushed aluminum dash kit. I'll hopefully have pics up soon. As for the price, I paid $45 Canadian from a local shop.
Thanks guys. Too bad I don't have any pics because the ebrake handle looks amazing with my brushed aluminum dash kit. I'll hopefully have pics up soon. As for the price, I paid $45 Canadian from a local shop.
Thread
Thread Starter
Forum
Replies
Last Post
03VQMAX
5th Generation Classifieds (2000-2003)
5
11-10-2015 03:39 PM