Who wants to be the first
Thread Starter
Senior Member
Joined: Jun 2001
Posts: 1,015
Who wants to be the first
The fly by wire accelerator setup is computer controlled. There seems to be a delay between the time you press the pedal and the motor responds. I know there is a way to close up that gap, but who wants to be the first to try? BMW had a switch on their 850i's that did that. Anyone out there might know a solution?
The problem will seem to go away after a few thousand miles of driving. After that the delay you experience will be from an inlet problem. When I had installed a 76.2mm MAF on my car I had a zero throttle delay. And the low end torque seemd to pick up quite a bit as well.
Originally posted by SR20DEN
The problem will seem to go away after a few thousand miles of driving. After that the delay you experience will be from an inlet problem. When I had installed a 76.2mm MAF on my car I had a zero throttle delay. And the low end torque seemd to pick up quite a bit as well.
The problem will seem to go away after a few thousand miles of driving. After that the delay you experience will be from an inlet problem. When I had installed a 76.2mm MAF on my car I had a zero throttle delay. And the low end torque seemd to pick up quite a bit as well.
Guest
Posts: n/a
Originally posted by SR20DEN
forums.max-world.com
forums.max-world.com
Originally posted by swallac2
Where? No such web site..... and www.max-world.com give me a page to register a page.
Where? No such web site..... and www.max-world.com give me a page to register a page.