i got the vb installed,just to make sure i could shift(carefully),
i got in the car and did the usual P-R-N-D-2-1
when i get to 1 it doesn't want to stay.
what did i miss?
Thanks i really need help here:>)

 

Anyone?Please_shift_me in the right direction

 

where did you get if from, call them and ask for help. mine is sitting in my garage waiting for me to return to nashville.

good luck

 

got it from maximum tuning,i'll call him monday...thanks any automatic guru's out there?

 

What do you mean it doesn't want to stay?

Also, did you add enough fluid?

 

this was a dry run without the car started i am just clicking through before i put the pan on and the fluid in.
I'm wondering if a pin is set wrong.

 

The groove in the pin should be facing the rear of the car. That's the only pin to worry about

 

thank you:>)
I'll check it out and get back

 

fileld it up with fluid and gave it a few minutes and she won't go into gear!
Leave it to me(F@#k)

 

Did you get a Tranny cooler, Which brand did you use, I wanan do the same with mines.
Were do you buy a VB Mod from anyways??

 

Did you get the spring on top of the VB lined up? Did you face the groove on the linkage pin towards the rear of the car?
Unless you missed one of these, everything should be fine.

Sorry it's not working. I know what a bi_tch it is to get that VB out.

 

o.k.--
after taking the pan off again,it was the pin,it wasn't lined up with the
shift linkage!
will finish it off tonight or tomorrow night.....the cooler is installed got it from advanced auto(equivilent to hayden 404)about $39.00

 

I'm a bit late but this was the problem right?

I have a write up on my homepage if anyone else needs it...


http://www.cardomain.com/member_page...=203031&page=5