Clutch pilot bushing 95 SE
Thread Starter
Newbie - Just Registered
Joined: Oct 2003
Posts: 6
Clutch pilot bushing 95 SE
Putting a new clutch in my 95 and there is NO WAY the pilot bushing goes on the input shaft. Did I lose a stepped spacer ?
The bushing OD is the same size as the input shaft OD and there is no smaller portion of the shaft that will fit inside the bushing .....
Am I nuts ?????
The bushing OD is the same size as the input shaft OD and there is no smaller portion of the shaft that will fit inside the bushing .....
Am I nuts ?????
Thread Starter
Newbie - Just Registered
Joined: Oct 2003
Posts: 6
Found the pilot bushing answer
The bushing is not USED !!!!!!!!!!
A pilot bushing is in the back of the crank and a new one included with the clutch when purchased. It seems that it is only used for the disc alignment and thats all.........
Crazy ...............
A pilot bushing is in the back of the crank and a new one included with the clutch when purchased. It seems that it is only used for the disc alignment and thats all.........
Crazy ...............
Thread
Thread Starter
Forum
Replies
Last Post
CAN-Toronto FS: Basement cleaning
knight_yyz
5th Generation Classifieds (2000-2003)
12
Nov 1, 2015 01:34 PM