I read on the board somewhere about buying the WC1000 to automate the opening and closing of the sunroof. I was wondering if anyone has done that and if so, how they wired it, and where they put the box. Also, I was curious if anyone had tried to link it into the remote opener to open the sunroof with the front windows.

It doesnt seem as simple as just following the directions, as there are not the same number of wires, nor are the voltages what is said in the instructions. I get a +12 constant on the yellow wire, ground on the two reds, and 0 on the green, when i open the sunroof the yellow, red, red/black are shorted, when i close it the green, red, red/black are shorted, so its bringing them to ground as the signal. Where am i supposed to splice in here?

 

http://www.vqpower.com/v2/modules.ph...howpage&pid=17