I have completely taken my regulator, motor, and window lifter out and tested each to see which one is the culprit and the motor seems to be working fine, i took the regulator apart and the grey spool inside is spinning freely. So i have come to the conclusion that it is not the actual mechanics that are messing up, but the circuit board under the control buttons. Any advise would be greatly appreciated in either fixing the problem or finding a replacement CB.

Holla!

 

try sanding the contacts down a little bit or get some electrical contact cleaner and try that. the contacts must just be dirty and in need of a good cleaning.

 

Try testing the motor and regulator. There is a two wire harness with blue wires close to the motor.
+12V to one wire and ground the other, it should go one way, switch the wires and it should go the other way