Does the OBD II Scanner be able to scan 95 Max? My cousin have one and we try to scan for code on a 95 max but couldn't find the plug-in harness for the OBD II scanner.....If 95 max do compatible then know where i can find the plug-in wire????

 

Well odds are you are looking under the drivers side of the dash but its on the passenger side under the dash to the right of the center console. I'm pretty sure I mean I have done it a couple times.

 

I have heard that the 95 max can be scanned with an OBD-II tool, it was equiped an abel to be scanned with the II rather than the OBD-I, forgot where I read it from.

 

I think the plug is next to your ECU comming out the right side.
(on a 95)

 

On my 99 max, the OBDII port is right by the fuse box on the left side of your steering wheel if you're looking at it. I heard that most 95 maximas are OBDII...so...

 

Uhm.. The OBD-II is on the passenger side right next to the ECU... for 95's...

 

YUP

 

All 1995 Maximas a OBD-II, everyone single one of them.

 

Tman, was that a question? If so then yes. Although I'm not sure they are fully OBD-II.

 

It's not a question. I was pointing it out. Every single 4th gen (95-99) are OBD-II

 

Thanks for all the point out where it located...much appreciation....I did located after all...Thanks once again to all the org members who help.

maxlauj95

 

the left side connector, near the fuse box, is for the tranny............

 

how come on the knee bolster, there is a label on my '95 that says it's OBD-I?

 

Actually, the connector by the fuse box is used by the Nissan CONSULT tool for both the ECM and the Tranny.

The connector on the front, right side of the console near the ECM is for a Generic Scan Tool (GST).