For those of you with the Addco RSB, where do you jack the rear of the car up from? I've been looking at the Addco bar for almost a year now, but I don't want to lose the ability to use the rear beam as a jack point (if possible).
Thanks!

 

A couple of years ago on the board someone suggested placing a spacer between the Addco bar and the U-beam axle in the mid point of the axle. I don't remember who now. I use a piece of aluminum plate about 3/8" thick by 6" square that I got from work. Slipping it in place between the RSB and the axle allows the jack pad to lift the car by the Addco bar. I use a block of 2x4 to pad the RSB from the jack. Be careful if you try to use plywood for the spacer since it may likely break.
-Mark