How Easy/Hard is it to install aftermarket headers. I already have the y-pipe off and it looks pretty easy for the front, but the back looks way harder, what do i have to do to get it off? any help is appreciated thanks

 

ANYBODY out there?

 

not sure but did ya get that chrome junk one off of e bay......i hope not

 

Unfortunately.....

 

dont put them on, ck around here they have alot of problems with them

 

like who? i tried to check on here before i bought them but couldn't find
anyone that had them..

 

Headers yield minimal gains on a naturally aspirated Maxima.

~THT

 

i really wouldn't put the stone racing ones on

 

I was just going to put the y-pipe by itself but it wont fit, i figured i had to use the
headers along with it in order to fit.

 

to put the rear headers on, you have to remove the intake manifold, and the egr. get a set of gear wrenches and deep sockets. it took Dave Sz, i30tmiked and me about two hours to swap the cattman headers rear bank out with the stockers one all of that was done. oh yeah, and we knew what we were doing.

 

damm and i'm working alone but i just wanted to make sure if had to remove the manifold or if there was an easier way. thanks for the help

 

you gonna go and do it, good luck bro just take your time then and do it right

 

i would get an extra set of hands, one person working from below and one person working from above.

good luck

 

did u get the OBX ones? I hear alot of bad things about those...but then again everyone just says just do the Ypipe seeing as headers arent that much of gain anyway.

 

no he got the stone racing ones.... extremely poor choice

 

stone racing sucks.
i hear it's easier if you tilt the engine when doing the rears.
unless you have cattmans, headers on a maxima are pointless.

 

whats so hot about cattmans?