I am installing beat in my car this weekend. I took the dash apart yesterday just to prep and to run the amp kit. I decided to leave it off until i finish with that section tomorrow. i also noticed thtat when i drove my car tonight that i have no blinkers. if i leave the hazard lights unplugged from its button will this cause the blinkers not to work. and is it because the ciruit is now open?

any ideas?

Thanks
-Stan

 

Plug in the hazards temporarily and your blinkers will work. It's not hard to get the harness out of the back of the button.

 

Your out of Blinker fluid man






Sike maybe the bulbs burned out?

 

He's right Plug the hazards back in and you're in business(open circuit)

 

Blinker fluid. Go to autozone and ask for it. They'll know what it is.

 

i went ther and the guy smacked me and kicked me out.............why did he do such a bad bad thing to me!

 

It's OK. He just did the same to his wife the night before.

 

I had the same problem during my audio install. Just do what the guys above said. Take the hazard light button out of its trim panel and hook it back up. Your blinkers will work then.

 

make sure to ask for GREEN blinker fluid. it's the best. makes your blinkers blink so much brighter, faster, and.... louder

 

thatnks guys install complete oh and i managed to top of the fluid too. i found an iridesent blue one that make the blinkers rapid fire like on a civic with one burnt out. but highly dangerous. guys at the sho said if i got hit in the blinker that would shurely die due to fall out. said it had radioactive properties