FS: BlehmCo Big Brake Kit 4th or 5th Gens.
Thread Starter
Joined: Apr 2001
Posts: 1,443
From: Long Island, NY
FS: BlehmCo Big Brake Kit 4th or 5th Gens.
Purchased these calipers from Jeff at Maximum Tuning for $358, rebuilt by his preferred builder and installed on my car by Jeff. These are the light aluminum 30mm calipers as can be seen by the heat-sink design, fit and finish. They were painted black and retained the bright silver Nissan logo. These were only on my car for 5k..
BlehmCo Brackets which are currently out of production since Matt is selling his business, check and see how hard they are to get now. (powdercoated silver)
Rotors were purchased directly from I-Rotors - 12.6, they were special order black zinc coated to match the black paint of the calipers. Rotors have a little bit of rust from getting wet after removal, except for that they are almost new and do not need to be resurfaced. Have approximately 5K miles, since thats how long they been on my car.
SS lines were purchased from Automax95 over at the big forum, these have the clear silicon coated sleeves and are in like new condition.
Im including the Hawk HPS pads since they have more then 2/3 of the pad left. All hardware was new for my install and was purchased from Courtesy Nissan.
And Ill even throw in a pair of Synthetic Valvoline Brake Fluid.
This works with either 4th or 5th Gens.
Full kit is a complete plug and play, ready to install and stop!!
Price is: $600.00
BlehmCo Brackets which are currently out of production since Matt is selling his business, check and see how hard they are to get now. (powdercoated silver)
Rotors were purchased directly from I-Rotors - 12.6, they were special order black zinc coated to match the black paint of the calipers. Rotors have a little bit of rust from getting wet after removal, except for that they are almost new and do not need to be resurfaced. Have approximately 5K miles, since thats how long they been on my car.
SS lines were purchased from Automax95 over at the big forum, these have the clear silicon coated sleeves and are in like new condition.
Im including the Hawk HPS pads since they have more then 2/3 of the pad left. All hardware was new for my install and was purchased from Courtesy Nissan.
And Ill even throw in a pair of Synthetic Valvoline Brake Fluid.
This works with either 4th or 5th Gens.
Full kit is a complete plug and play, ready to install and stop!!
Price is: $600.00
Thread Starter
Joined: Apr 2001
Posts: 1,443
From: Long Island, NY
Thread
Thread Starter
Forum
Replies
Last Post
MAXSE5SPD
General Maxima Discussion
33
Sep 17, 2022 04:00 AM
pktaske
6th Generation Classifieds (2004-2008)
1
May 6, 2016 07:49 AM