What amp should I get to push these speakers (orion series 2)

 

AMP SELECTION WOULD DEPEND ON YOUR WIRING CONFIG. A SINGLE 4 OHM DUAL CONE SUB CAN BE WIRED TO BE JUICED AT 2 OHMS (CONES CONNECTED IN PARALLEL) TO AN AMP WITH A SINGLE CHANNEL RATED AT 2 OHMS OR AT 4 OHMS ON AN AMP WITH TWO CHANNELS, ONE CHANNEL FOR EACH CONE. FOR TWO DUAL CONE SUBS AT 4 OHMS, THE BEST AMP WOULD BE AN AMP CLASSIFIED AS A MONO (1 CHANNEL) AMP, ASSUMING THAT YOUR WIRING IS DONE IN PARALLEL. CHECK OUT SOME AMPS FROM KICKER.

 

Easy with the caps there........

 

JL5001