Hello, I have two 12mm hubcentric wheel spacers for sale. 5x114.3 bolt pattern and 66.1mm centerbore. I originally bought these for the rear wheels of my 4th gen maxima, but they do not sit flush with the rotor due to the hub and dust cap.

$30 shipped

 

Do you have the extended studs for these?

 

Sorry, I don't have extended bolts because they didn't come with any.

 

bring up my post

 

You have a picture of the thickness? Also was the center hole too small or too large to fit over the middle hub? Interested but I'm looking for a set to fit my rears also.

 

The centerbore is 66.1mm so it slides over the hub just fine. The issue is that the rear hub lip of the 4th gen is about 15mm. On the 12mm wheel spacer there is another lip on the inside (see photo below) that prevents it from sitting flush with the rotor.



Here is the photo of the thickness next to a 15mm spacer. The 15mm is for sale if you are interested. Used for about 30 miles and fits the rears perfectly.

 

OK you got PM.