MD FS: Shortened Koni Yellows on Eibach springs
FS: Shortened Koni Yellows on Eibach springs
I thought I was going to use this setup again in the winter, but I'm too lazy to remove my coilovers, so I think I should sell these.
I'm selling my old Koni Yellow/Eibach setup that was on my car for about three years/25k miles. JSutter trimmed about 1" from the front Konis to regain lost wheel travel, so these ride much better than your average spring/strut setup and rarely bottom out. The Konis are dry as a bone and have never leaked any fluid. The entire setup is still FULLY ASSEMBLED, so these will just bolt into your car, no assembly required.
When I put this setup together I bought every rebuild part from Dave B, which totaled about $250. This included mounts, gaskets, bolts, EVERYTHING. This setup never made a squeak and is still in great condition. These is some surface rust on the Konis, but it's nothing to worry about. I'll try to post up some pics later.
Between the Konis, the labor trimming them, Eibachs and Nissan parts, I had about $1,000 in this setup. I'm looking to get $500 shipped as there is still plenty of life in the Konis and they can be easily rebuilt/revalved for not a ton of money. Shoot me a PM if you're interested.
Thanks for looking!
-Nick
I'm selling my old Koni Yellow/Eibach setup that was on my car for about three years/25k miles. JSutter trimmed about 1" from the front Konis to regain lost wheel travel, so these ride much better than your average spring/strut setup and rarely bottom out. The Konis are dry as a bone and have never leaked any fluid. The entire setup is still FULLY ASSEMBLED, so these will just bolt into your car, no assembly required.
When I put this setup together I bought every rebuild part from Dave B, which totaled about $250. This included mounts, gaskets, bolts, EVERYTHING. This setup never made a squeak and is still in great condition. These is some surface rust on the Konis, but it's nothing to worry about. I'll try to post up some pics later.
Between the Konis, the labor trimming them, Eibachs and Nissan parts, I had about $1,000 in this setup. I'm looking to get $500 shipped as there is still plenty of life in the Konis and they can be easily rebuilt/revalved for not a ton of money. Shoot me a PM if you're interested.
Thanks for looking!
-Nick
Thread
Thread Starter
Forum
Replies
Last Post
MaxLvr21
5th Generation Maxima (2000-2003)
14
Oct 17, 2015 12:11 PM
JakeOfAllTrades
7th Generation Maxima (2009-2015)
1
Sep 30, 2015 03:16 PM
followthadollar
4th Generation Maxima (1995-1999)
3
Sep 27, 2015 01:06 PM






