IA 00VI setup, most parts you'd need - $150
00VI setup, most parts you'd need - $150
Edit 5/27 - SOLD
Located in zip 52577.
I have the following 5th gen parts from a 2000 Max that if I remember correctly had 80K miles:
UIM - upper intake manifold with throttle body and most mounting brackets (tested the VI before uninstall)
LIM - lower intake manifold
Fuel rail with injectors and bits of pigtail harness
Rear valve cover
EGR valve, free standing + pigtail
TPS and IACV still attached to the throttle body__ pigtails
Rear coil packs, grey dot... little bitty pigtail
+ every bolt obtained during uninstall
I bought this set up some time back when I had my 97, with the intention of this mod but I sold the car shortly after, so this set up has not been installed on a 4th gen yet. At this time, I would like to sell it all together.
150 bucks and buyer pays shipping/ picks up.
Give me an email/cell number and I'll send pictures
Located in zip 52577.
I have the following 5th gen parts from a 2000 Max that if I remember correctly had 80K miles:
UIM - upper intake manifold with throttle body and most mounting brackets (tested the VI before uninstall)
LIM - lower intake manifold
Fuel rail with injectors and bits of pigtail harness
Rear valve cover
EGR valve, free standing + pigtail
TPS and IACV still attached to the throttle body__ pigtails
Rear coil packs, grey dot... little bitty pigtail
+ every bolt obtained during uninstall
I bought this set up some time back when I had my 97, with the intention of this mod but I sold the car shortly after, so this set up has not been installed on a 4th gen yet. At this time, I would like to sell it all together.
150 bucks and buyer pays shipping/ picks up.
Give me an email/cell number and I'll send pictures
Last edited by Ed Bwoy; May 27, 2015 at 07:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post
MR2 T'd
5th Generation Classifieds (2000-2003)
6
Jul 9, 2021 05:06 AM