Hi.. I have a 2K1 Max SE and would like to take the door panel off. I got as far as taking off the 2 screws and removing the cup? I tried prying it but panel is not budging. Is there another step? Thanks.

 

Did you try prying it from that hole/slot at the bottom of the panel? If so try it.

I'd also recommend you get that prying tool (looks like a fork with a large curved head) as it makes it a lot easier and you don't risk the chance of breaking any of the plastic snap-holders.

If i remember correctly there's 3 snap holders on the door... forgot the exact locations. Try searching around the board, i remember someone posting a scanned Crutchfield installation sheet.

 

Pull REALLY hard! Just don't plan on putting them back on.

(

(sorry...I couldn't resist)

 

There's a screw in the door cup and a screw at the far inside part of the door nearest to the hinge. You also need to remove the trim plastic around the door handle. After that, pull up on the door from the handhold at the bottom of the door. If you want the Crutchfield instructions that show you how to remove the panel, email me with your email address and I'll send them to you tonight.

 

Hey Tan, you never got back to me on my last e-mail. I presume you don't want the Infinity's no more?

 

I was looking at the same thing so I have the info. Here it is:

http://www.sweetcar.org/doorTrim.pdf

 

In his diagram, you only remove parts 1,2,4,5 for the front doors and
8,9 on the rear doors. Pull out and then up on the door at points 7 and 12.

 

Sorry man, had some things to take care of and I didn't check that account for a while. My setup is working ok and I'm really very, very tired of messing with it. Sorry to keep you hanging. Hopefully you can still sell the parts or keep them for spares.

Later,

Tan

 

NP. I'll just pass it on to the next "Tanmann" that comes

 

I got it and its very helpful. Thank you very much all!