I just ordered KYB AGX from Nick (nice guy & good service) for 350.00 shipped and Sprint Springs...

What else do I need to install these? I've read that I should go to Radio Shack and get Wire Loom to wrap around the spring?

Also, do I need to rent another spring compresser to do this job? I've also read tha tthe Sprints fit right in?

Should I cut 1 coil off the rear to have it sit even? I believe Supa Lao did this...\

What are your experiences...???

 

I got the wire wrap from Radio shack for my springs. I also got the AGX dust boots from Cattman because my OEM ones were shot. The back of my car sits higher than the front, and I do sometimes think about cutting a coil, but I figure once I put the stereo in then it'll even out a bit.

Later,
-Nick

BTW, Supa Lao did do this on his car and it looks nice.

 

Hey Nick... I have a 100lb speaker box in my trunk and it really doesn't do much.... I think Supa Lao does too... No?

Where else can I get dust boots? Just plain old wire wrap?

 

There is a suspension sticky at the top of this forum that has a list of all of the bushings and parts recomended to change when you do the suspension. I would check there that is where I got my parts list from. Not trying to flame just letting you know it is there.