I drive a 2002 nissan maxima gle the ac control lights stopped worning but it's only the middle bitton , the mode and the fan spees button the left side works fine is it im not sure if its a fuse or maybe they just burnt out

 

Does your A/C still turn on? If so, then the bulb is burnt out. If not, you will have to diagnose why not.

 

burned out. They are available from the dealership and there is a how to somewhere on how to get to them to swap. The old ones will practically fall out while the new ones will be a really tight fit.

 

The ac works i have wanted to switch the color to like red instead of white now i have an escuse to is there like a diy on the forums?

 

It shouldn't be that hard, just pull apart the climate control module and find the button/bulb you're looking for. It's more than likely held together with plastic snaps or small screws.

 

What bulbs do i get

 

If only a utility existed that allowed you to type in anything you wanted and get millions of suggestions.

 

common problem and how to thread, please search . a good search would be ACC unit lights

 

Like this

 

I do want to warn you that replacing the bulbs can end up in some of them not working. If its really important to you, then order extras.

 

Take a pic. and post it. I think i have the same problem.

 

yes replace all 3 while u have it opened up,

i did this already , adn same two burnt out again cpl years later, i think theres a more long term fix w like a solder , i feel one member figured out the real cause of the early burn outs.

 

the problem is the contacts on the board clean them with sand paper first


and the Eagles Suck

 

 

The fixer do you do custom led work?

 

thanks for that !! soudns right !! i need to replace mine a 2nd time and have blubs waiting to be put it, but its just blah ....for a cpl light bulbs rip out half of ur dash...
i need to get rid of that, i dont even like pro sports any more ! missed last two super bowls w pride.

 

Yes i do

https://www.facebook.com/groups/LedSwaps/

https://www.facebook.com/groups/LedSwaps/

 

Also the aftermarket bulbs your most likely getting from SBL they are not the correct size i have swapped out hundreds of sbl leds for the ones i make and i use 100% oem bulb holders.

 

i did OEM twice, no one said aftermarket

 

https://www.facebook.com/groups/LedSwaps/