Pulling Codes on an 87 SE
03-15-2003, 05:34 PM
#2
Senior Member
Join Date: Aug 2000
Posts: 2,807
with the search down I'm afraid that I'll walk you through it 
. Remove the passenger seat with a 8mm socket (you will have to move it forward to reach the rear bolts, then unplug the connector if it is a powerseat and remove the seat belt. Next remove the cover from the ecu and look on it's side. You should see a small hole with a screw that has a flathead on it. For further instructions right click and save the link below to your hard drive.
Try saving this link.
http://www.geocities.com/nismo87se/ECU.jpg
. Remove the passenger seat with a 8mm socket (you will have to move it forward to reach the rear bolts, then unplug the connector if it is a powerseat and remove the seat belt. Next remove the cover from the ecu and look on it's side. You should see a small hole with a screw that has a flathead on it. For further instructions right click and save the link below to your hard drive.Try saving this link.
http://www.geocities.com/nismo87se/ECU.jpg
Thread
Thread Starter
Forum
Replies
Last Post
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM
hayne
6th Generation Maxima (2004-2008)
2
10-05-2015 11:53 AM