My compressor isn't engaging. The light on the a/c button is coming on, but that's it. My car has super low mileage (63k), has never been in a corrosive environment and has always been in the garage.

I checked the fuse, and it's fine. I'm not sure how to test the relay, but I did pull it out and put it back in. I'm doubting it's the compressor, but I'm not 100% sure about that. The haynes manual gives no clues as to troubleshooting, and I don't have an FSM yet.

If anybody could throw some suggestions my way, I'd appreciate it. I don't want to take it into the shop just yet.

 

not thoughts on the ac comperssor but congrats on that clean max...i wish my paint was that good...

 

If could be possible you are low or out of coolant. Even with that low of miles, not using the A/C on a regular basis can cause seals to dry out and leak.

Also I would verify if the compressor clutch is engaging or not. You should hear a distinct click and the center of the clutch should begin spinning.

S

 

The clutch is not engaging.

 

You might want to try replacing the relay. Even if you are low/out of coolant, it should still spin for at least a few seconds before immediately disengaging.

S