Torquing Right (Firewall ) Cam Gear Bolt

Reply Subscribe

Thread Tools

Search this Thread

Jul 29, 2011 | 10:09 AM

Edge

Thread Starter

Member

Joined: May 2002

Posts: 184

Torquing Right (Firewall ) Cam Gear Bolt

Anyone manage to get a torque wrench on the right (firewall) cam shaft gear bolt? It not, how did you torque it? Too tight in there with the power steering lines.

Jul 29, 2011 | 07:24 PM

CMax03

Senior Member

iTrader: (3)

Joined: Oct 2007

Posts: 9,587

From: Houston, Tx

Quote:

Originally Posted by Edge

Anyone manage to get a torque wrench on the right (firewall) cam shaft gear bolt? It not, how did you torque it? Too tight in there with the power steering lines.

a 3/8" drive torque wrench with a shallow 14mm socket can be done all day! Or place a boxed end wrench on the cam sprocket bolt and torque the cam retaining bolt on the transmission side of the engine!

Jul 30, 2011 | 06:20 AM

Edge

Thread Starter

Member

Joined: May 2002

Posts: 184

I did manage to get my 1/2 torque wrench behind the pwr strg lines and on the cam bolt. Too bad my 3/8 wrench only goes to 250 in-lbs.

Quote:

Or place a boxed end wrench on the cam sprocket bolt and torque the cam retaining bolt on the transmission side of the engine!

Now your thinking out of the box

Last edited by Edge; Jul 30, 2011 at 06:42 AM.

Jan 7, 2012 | 11:17 PM

CMax03

Senior Member

iTrader: (3)

Joined: Oct 2007

Posts: 9,587

From: Houston, Tx

Quote:

Originally Posted by Edge

I did manage to get my 1/2 torque wrench behind the pwr strg lines and on the cam bolt. Too bad my 3/8 wrench only goes to 250 in-lbs.

Now your thinking out of the box

Both mine are rather high....My 3/8 " drive Snap-On Torque wrench is 1000 in/lbs and my Craftman is 75 ft/lbs (900 in/lbs).....