This is all i have left of the part out from my 1992 SE VE 5 spd maxima and motivated to get rid of,as i don't have any use for them.Price on most are OBO but be reasonable as i think they are very good as they are. the prices do not include shipping,but will ship anything.

Here the link to all the parts:
Prices for parts are above pic of the part
http://s65.photobucket.com/albums/h2...ff%204%20sale/

Dont know what happened to the mas here, guess it fell and broke the corner off.



Jim Wolf Technology ECU:SOLD!!!


As you can see a few things have been taken off the the motor so it not "COMPLETE" so i have adjusted the price a bit.

Parts that are missing from the motor
Fuel rails,Injectors,alternator,engine brackets,think that's it.

Here is list of what has been done to the motor.
Bored .20 over with 11:8 compression JE Pistons (if memory serves me correctly) with eagle rods.
Engine fully balanced
Crankshaft has been fully balanced and lightened
Heads,exhaust manifold have all been extrude and honed
Heads have been fully rebuilt. New (OEM valve seals, springs,retainers,valves,camshafts,lifters)
every seal,gasket has been replaced
new knock sensor
everything for the timing has been replaced new chain,sliders,tensioners,etc

If you need individual parts im willing to take motor apart and sell you what you need. But would like to sell as a whole first as it runs very good.

For anyone interested im just being up front here,Sometimes there is a slight tick/knock noise from around the VTC area.Not a real big deal,easily fixed with the "motor out" or could just ground them.

 

interested on the ecu and the tranny. hit me up espimax@verizon.net

 

Money send for the ecu. thanks

 

If you are up to it, I could use the con rods. But I'm not sure. As far as the research I've done, the bottom end is the same as the VG30DE right? If so, How much for the rods? Shipped to 23702? Thanks a bunch.

 

Hello, I was hoping you would help point me in the right direction ?
Short Version:

1990 nissan maxima, replaced clutch and now... looking for a bellhousing, + clutch (master to slave) hose #30855-85E10 + transmission leaks (gushes) engine oil )..(help)
I live by DFW airport (euless,irving,arlington) I am frustrated with searching and am asking for directions.
I really appreciate any input you have to share, there are others out there(i just know it) ..

I appreciate you,
michele (chelebellyalso@yahoo.com)

 

I got your message that you sent me. I am not exactly sure what you are talking about. Why are you looking for a bellhousing....that would not cause anything to leak. If you are loosing engine oil though the bell housing then I would guess you messed up your rear main seal.

On another note, you should probably not post this in someones for sale add.