UPDATE THIS WAS SOLD ON 9-18-2010


TRANSMISSION MODEL # RS5F50V w\ VLSD LIMITED SLIP DIFFERIENTIAL from a 92-94 maxima se
these transmissions are getting hard to find and any used ones out there probaly have bad input shaft bearings or worse
this is a 5 speed manual transmission from a 199 2 199 4 nissan maxima se its been opened up and cleaned out and 2 of the front gear-shaft bearings have been replaced
the gearshafts are still complete all the parts are there
SPINGS CLIPS CHECKBALLS ETC.
remember the housing \ case is still off

AND it has all the related parts for a 5 speed swap into an automatic car the cars ecu, the trans ecu, upper intake, clutch ,flywheel ,Mounts, axles, both front spindle\hubs, shifter
shifter linkage ,clutch pedal and master clyinder, slave clyinder, more etc.
im around seattle and northwards MAKE AN OFFER

NOTE*the 2 front gear- shaft bearings were put on, i left the
gear shafts all together ,i still have the spings clips and checkballs,
it could prob be just slapped back together and used OR a shop could put it together and check all the other stuff

also i think it may need the passenger axle carrier bearing bracket to be a complete 5 speed swap

 

its auto? or ...
if its a manual, want to ship it to ga?

 

ITS A MANUAL!,if you can find out what it cost to ship?
also re - read my edited post up top and it has new details

 

anybody local that wants this MAKE ANY OFFER?

 

How much because I will probably need one soon. I will find out how much shipping is.

 

if you want it i'd be shipping from 98046 or 98037 if thats even possible?
and id like someone to take all the related parts too.
make any offer i guess

did you read that it was taken apart( but left opened up so whoever, could decide if they wanted to invest more in a full rebuild or just slap it together
since its very cheap)and all the pieces are there=clips,springs,checkballs
also 2 new front gear- shaft bearings were installed!

 

You sure you didn't just forget how to put it back together?

There's only 1 front input shaft bearing.. The beefier one is the rear bearing, and shouldn't fail, but oh well can't hurt to replace both..

 

I just need to clear out stuff,its from a parts car i had like 3-4 years ago
buy it and one up me by putting it together...make any offer

 

give it to me free! ill pay shipping to saint mary's GA 31558 ...
or $1 + shipping... your call
come on, i need to built it anyway to handle all the power i got running to my tranny... i need to stop burning out only 1 wheel!

 

i was hoping for a local sale,and more like $100
which includes all related 5 speed parts

 

but your all the way in MA ... thats like 1000 miles away, im not too local, ill ask my brother to come get it ... then ship it to me... ill get back to you

 

im in washington
you must have seen by my name
the nissan masta-ma(maxima) and thought -ma.

 

UPDATE THIS WAS SOLD ON 9-18-2010