Jesse93GXE

So far my work on my car has just consisted of general maintenance and interior stuff (mostly my car comp). Anyway, I installed an FSTB I got from Stealth Max today. Had a questions for you guys... did a search and found lots of install instructions (very handy), but nothing specifically addressing my question.

The length of the bar is adjustable by turning the end-bolts on the bar. Is it important that the end-bolts be the same length? I had the passenger side on mine a bit shorter to provide more clearance to my AC pipe (which I had to bend/rotate out of the way).

So is okay to have the bar slightly off-center (unequal end-bolt lengths), or do I need to make the ends the exact same length?

Matt93SE

iTrader: (44)

As long as it's bolted into place securely, it'll do it's job. other than that, no, it doesn't matter if one side has 1/8" more thread than the other. Just make sure everything is snug on them when you're done, and it's fine.

Jesse93GXE

Thanks Matt!

The thread length difference is about a full inch.

Everything is nice a snug. Looking forward to going on some twisties this weekend and seeing whether there's a difference.

lophix

iTrader: (3)

does stealth max sell normally or it was just one he had on hand.

Jesse93GXE

Stealth Max regularly sells them and has been for a long time. He should have one if you email him.