Okay... here's the deal. You can all laugh at me later. I needs some help assembling the pulley that adjusts the tension on the power steering belt. I unscrewed it all the way and if fell off, hit the ground, and all of the pieces scattered everywhere. There are two large washers, that arnt the same size, the pulley, and the bracket it all fits in. Thing is, I dont know how any of it goes back together, dont know if the washers are on the outside of the braket or on the inside flush with the pulley. Any comments would be appreciated, even the smart *** comments... Could use a bit of humor right now. Thanks

 

man that sucks, sorry to hear that.

i don't recall an exploded picture of the pulley in my manual.

if i had to guess, one washer per side between the pulley and teh bracket. i'd put the larger pulley in the back and smaller in front.

anyone else have comments?

EDIT:
I meant to say "larger washer", not pulley, but I'm sure you figured that out.

 

sounds logical to me

 

this might help, it's about all the FSM has on the PS pump




good luck