Ticking that isn't my manifold studs?

Subscribe
Jan 1, 2005 | 08:52 PM
  #1  
I've noticed that my Max has got a noise that sounds like a ticking/tapping noise. I mostly hear it when I'm pulling in between 2 parked cars, or near a wall or whathaveyou. If its very cold out side sometimes I'll hear it when the revs get a little higher, then I shift and it'll stop, then happen again. Once the engine gets real nice and warm, it'll stop being noticeable...until I park near a wall or between cars heh.

Any ideas? VG engine. I was thinking valves/lifters, but I'm not very familiar with this engine.

I was thinking this could be my manifold studs, but its too quiet for that, and mine aren't that old.

I'm also pretty sure that I've got a weeping head gasket :| Its not getting into the oil or burning, but the smell is there. I think its just running down the block somewhere.
Reply
Jan 2, 2005 | 12:49 AM
  #2  
You can check your manifold studs. Take a flashlight and look around the manifold area. There will be 6 per side. Also, when the engine is cold, just "feel" for them.
Reply
Jan 2, 2005 | 08:53 AM
  #3  
my max makes simmilar noise here >> http://webpages.charter.net/sabre83/Max/Max.mpg Listen to that
Reply
Jan 2, 2005 | 11:45 AM
  #4  
Thats louder than mine and sounds different. No good though :-\
Reply
Jan 2, 2005 | 03:34 PM
  #5  
possible water pump bearing failure? Not to familar with the max's water pump but from what I have read it is somewhat prone to failure. Plus you say you smell antifreeze. Just a thought. Could be way off. lol
Reply
Subscribe