i bought a front motor mount from internet automart and when i went to put it in only one bottum bolt would fit in...the back one just will not line up. it looks like the mount was bent a little to much during production so i drove on it bit to see if it would snug it's way into place but no luck..any one know tricks to getting the things on?

 

r u certain that it's the right one?

 

Hopefully you already tried to contact him before you posted this.

 

Did you stick a jack under the motor and fiddle with it?

 

my priest says i'll go to hell if i keep doing that




sorry, i couldn't resist

 

are you sure you didnt put it in backwards

how close is it really close or cant even begin to see the hole

you might have to jack up the other side to get it if its close

 

Yeah if it is the right one you may have to fiddle with it for a bit to get it to line sometimes they can be a pain in the a$$

 

it is the right one..and the holes sorta line up so maybe i do have it in backwords.....but ive tried both ways hmmmm

 

if you can see the hole get a screw driver in the hole and you should be able to persuade it so you can line up a bolt i remember haveing a simalare problem when doing this