need some help on installing the (R) lower arm control
03-10-2007, 12:09 PM
#241
ActiveTuning Partner
Join Date: Nov 2001
Posts: 157
Oops! Thanks. I thought I was searching in fourth gen. when I found this thread.
But I may as well end the story. I got the ***** back in, added another dose of CV grease, and said screw the clip. I found that it went in the a groove in the OD of the cup end of the joint to keep the ***** from pulling out. Well, she pulled the ***** out right past the clip. Anyway, once its all assembled the ***** can't come out that far anyway.
Our little local dump of an auto parts store sold me the only clamp they had which was a hair too small. Luckily I had some giant 38DD size zip ties that should keep the grease in until I can drive it somewhere to get a real clamp installed - and maybe the retainer ring.
Steering wheel is off 1/8 turn so it needs an alignment, and the brakes are seriously rusty, but its on the road again.
But I may as well end the story. I got the ***** back in, added another dose of CV grease, and said screw the clip. I found that it went in the a groove in the OD of the cup end of the joint to keep the ***** from pulling out. Well, she pulled the ***** out right past the clip. Anyway, once its all assembled the ***** can't come out that far anyway.
Our little local dump of an auto parts store sold me the only clamp they had which was a hair too small. Luckily I had some giant 38DD size zip ties that should keep the grease in until I can drive it somewhere to get a real clamp installed - and maybe the retainer ring.
Steering wheel is off 1/8 turn so it needs an alignment, and the brakes are seriously rusty, but its on the road again.
Thread
Thread Starter
Forum
Replies
Last Post
95Maxi
4th Generation Classifieds (1995-1999)
35
09-02-2015 10:37 AM
soon2ownmax
6th Generation Maxima (2004-2008)
0
08-13-2015 02:19 PM
laparka66
7th Generation Maxima (2009-2015)
16
08-06-2015 09:36 AM